HP ProOne 440 G3 23.8-inch Non-Touch All-in-One PC User Manual

Browse online or download User Manual for Unknown HP ProOne 440 G3 23.8-inch Non-Touch All-in-One PC. HP ProOne 440 G3 23.8-inch Non-Touch All-in-One PC

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
854283-121 1
Optical Drive Replacement Instructions
Before you be
g
in
Observe the following requirements before removing
and replacing the optical drive.
WARNING: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING: Avoid touching sharp edges inside the
computer.
CAUTION: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Hex tool
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
Removing the optical drive
1. Disconnect the power cord and all attached cables from
the back of the computer.
2. Using caution, lay the computer down on a flat
surface covered with a soft cloth.

854283-121
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - 

854283-121 1 Optical Drive Replacement Instructions Before you begin Observe the following requirements before removing and replacing the optic

Page 2

854283-121 2 3. To remove the stand, rotate it upward (1), remove the four hex screws (2), and then lift the stand up and off the computer (3). 4.

Page 3

854283-121 3 Replacing the optical drive 1. Position the bracket on the back of the optical drive, and then replace the two Phillips screws. 2.

Page 4

854283-121 4 Instructions pour le remplacement du lecteur optique Avant de commencer Respectez les exigences suivantes avant de retirer et de re

Page 5

854283-121 5 3. Pour retirer le socle, faites-le pivoter vers le haut (1), retirez les quatre vis à tête hexagonale (2), puis soulevez le socle ve

Page 6 - St at ement(s) as per sp ec

854283-121 6 Réinstallation du lecteur optique 1. Placez le support à l'arrière de l'unité optique, puis remettez les deux vis. 2.

Comments to this Manuals

No comments