HP ProDesk 600 G4 Base Model Small Form Factor PC User Manual download pdf (Page 111)

A Battery replacement

The battery that comes with the computer provides power to the real-time clock. When replacing the battery,

use a battery equivalent to the battery originally installed in the computer. The computer comes with a 3-volt

lithium coin cell battery.

WARNING! The computer contains an internal lithium manganese dioxide battery. There is a risk of re and

burns if the battery is not handled properly. To reduce the risk of personal injury:

Do not attempt to recharge the battery.

Do not expose to temperatures higher than 60°C (140ºF).

Do not disassemble, crush, puncture, short external contacts, or dispose of in re or water.

Replace the battery only with the HP spare designated for this product.

CAUTION: Before replacing the battery, it is important to back up the computer CMOS settings. When

the battery is removed or replaced, the CMOS settings will be cleared.

Static electricity can damage the electronic components of the computer or optional equipment. Before

beginning these procedures, ensure that you are discharged of static electricity by briey touching a grounded

metal object.

NOTE: The lifetime of the lithium battery can be extended by plugging the computer into a live AC wall socket.

The lithium battery is only used when the computer is NOT connected to AC power.

HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable

batteries. For more information about recycling programs, go to http://www.hp.com/recycle.

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB ash drives, from the computer.

3. Turn o the computer properly through the operating system, then turn o any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as

the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to

the internal components of the computer.

5. Remove the access panel.

6. Locate the battery and battery holder on the system board.

NOTE: On some computer models, it may be necessary to remove an internal component to gain access

to the battery.

7. Depending on the type of battery holder on the system board, complete the following instructions to

replace the battery.

Type 1

a. Lift the battery out of its holder.

103

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 123 124

No comments

HP ProDesk 600 G4 Base Model Small Form Factor PC User Manual Page 111