HP EliteDesk 800 G3 Tower PC User Manual download pdf (Page 20)

August 2018

919946-003

HP PC Commercial BIOS (UEFI) Setup

4 Security Menu 20

4.4 BIOS Sure Start Menu

Settings menu for Enhanced hardware based assurance that only HP approved Embedded Controller firmware will run on

the HP Embedded Controller and that only HP approved BIOS will run on the host CPU.

Table 11 BIOS Sure Start Menu features

Feature

Type

Description

Default

Notes

 Verify Boot Block

on Every Boot

Setting

When not checked, HP Sure Start© will verify the

integrity of HP firmware in the non-volatile (flash)

memory before resume from Sleep, Hibernate, or Off.

When checked, HP Sure Start© will verify the integrity of

HP firmware in the non-volatile (flash) memory across

operating system restart (warm reset) in addition to

resume from Sleep, Hibernate Off. This setting provides

higher security assurance, but could increase the time

required to restart operating system.

Unchecked

Reboot

Required

BIOS Data Recovery

Policy

Setting

The following settings are possible for HP Sure Start –

Recovery Policy:

• Automatic

• Manual

Automatic: HP Sure Start will automatically repair any HP

firmware integrity issues in the non-volatile (flash)

memory

Manual: HP Sure Start will not repair any HP firmware

integrity issues in the non-volatile (flash) memory until

the Windows +Up Arrow+ Down Arrow keys are pressed.

NOTE: Manual recovery is intended for use by the system

administrator in the event forensic investigation is

desired before HP Sure Start repairs the issue. It is not

recommended for the typical user.

Automatic

Reboot

Required

Network Controller

Configuration

Restore

Action

HP Sure Start – Network Controller Configuration Restore

This action will restore the network controller

parameters to the factory state saved in the HP Sure

Start Private non-volatile (flash) memory.

NOTE: This process can take up to 30 seconds. You only

need to restore this when the Network Controller

Configuration mismatch warning is set.

Reboot

Required

 Prompt on

Network Controller

Configuration

Change

Setting

When enabled, HP Sure Start will monitor the network

controller configuration and prompt the local user if any

changes are detected compared to the factory

configuration. The local user has the option to ignore the

prompt, or restore the network controller to the factory

configuration when prompted.

Checked

Intel only

Reboot

Physical

Presence

Required

 Dynamic Runtime

Scanning of Boot

Block

Setting

When checked, allows HP Sure Start will verify the

integrity of the HP firmware in the non-volatile (flash)

memory every 15 minutes while the system in the On

state with the user operating system active

Checked

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Comments to this Manuals

No comments

HP EliteDesk 800 G3 Tower PC User Manual Page 20

Comments to this Manuals

Related products and manuals for Unknown HP EliteDesk 800 G3 Tower PC