HP 16500A User Manual download pdf (Page 150)

What Am I

Going to

Measure?

After configuring the logic analyzer and hooking it up to your circuit

under test, you will be measuring the time (x) from when the RAS goes

low to when the CAS goes high, as shown below.

How Do I

Configure the

Logic Analyzer?

In order to make this timing measurement, you must configure the logic

analyzer as a timing analyzer. By following these steps you will configure

Analyzer 1 as the timing analyzer.

If you are in the State/Timing E Configuration menu you are in the right

place and you can start with step 2; otherwise, start with step 1.

1. Touch the field in the upper left corner of the display and select

State/Timing E.

2. In the State/Timing E Configuration menu, change Analyzer 1

type to Timing. If Analyzer 1 is already a timing analyzer, go on to

step 3.

a. Touch the field Type: _________ .

b. When the pop-up appears, touch Timing.

Figure 7-1. RAS and CAS Signals

Using the Timing Analyzer HP 16510B

7 - 2 Front-Panel Reference

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 271 272

No comments

HP 16500A User Manual Page 150