HP 16500A User Manual Page 121
- Page / 272
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
4 Count The Count field allows you to place tags on states so you can count them.
Counting cuts the acquisition memory in half from 1k to 512, and the
maximum clock rate is reduced to 16.67 MHz.
Selecting this field gives you the following pop-up menu.
Off.IfyouselectOff, the states are not counted in the next measurement.
Time.IfyouselectTime counting, the time between stored states is
measured and displayed in the State Listing under the label Time. The
time displayed can be either relative to the previous state or to the trigger.
The maximum time between states is 48 hours.
Figure 5-71. Count Pop-up Menu
HP 16510B Menus
Front-Panel Reference 5-61
- HP 16510B 2
- Logic Analyzer Module 2
- Printing History 3
- List of Effective Pages 4
- Introduction 5
- Contents 6
- Chapter 4: Using the Menus 7
- Chapter 5: Menus 8
- Chapter 9: State Compare Menu 11
- Chapter 11: State Chart Menu 11
- Chapter 13: Using a Printer 12
- Appendix B: Error Messages 13
- General Information 15
- Configuration 16
- Capabilities 16
- Accessories 17
- Supplied 17
- Available 18
- The HP 10269C 20
- General Purpose 20
- Probe Interface 20
- The Termination 21
- The HP 16510B 22
- Probing System 22
- Disconnecting 28
- Labeling Pods 30
- Probes, and 30
- Using the 31
- Select Menus 32
- How to Close 34
- Pop-up Menus 34
- How to Select 34
- How to Enter 36
- Numeric Data 36
- Alpha Data 37
- Roll Data 39
- Assignment/ 41
- Specifying 43
- Patterns 43
- Specifying Edges 44
- Using the Menus 45
- State/Timing 46
- Menu Map 46
- Timing Format 47
- Timing Trace 48
- Using the Menus HP 16510B 50
- 4 - 6 Front-panel Reference 50
- State Format 51
- HP 16510B Using the Menus 53
- Front-Panel Reference 4 - 9 53
- State Compare 55
- State Waveform 56
- Front-Panel Reference 4 - 13 57
- State Chart 58
- Front-Panel Reference 4 - 15 59
- Mixed Display 60
- System Level 61
- • State Format Specifications 66
- • State Trace Specifications 66
- • State Listing 66
- • Symbols 66
- Timing and State 69
- 5Specify 74
- • Symbol Width 75
- • Symbol name 75
- 1 Run/Trace 88
- 3 Acquisition 90
- 7 Pattern 97
- Duration (present 97
- State Trace 103
- Specification 103
- Sequence 107
- 3Storage 109
- Qualifier 109
- 4 Branching 109
- 5 Occurrence 110
- Reading the 113
- Level Display 113
- Acquisition 115
- Qualifier and 125
- Pattern Fields 125
- Interpreting the Display 129
- Waveforms 130
- Menu Fields 130
- (Timing) 131
- • Less than 133
- • Greater than 133
- • In range 133
- • Not in range 133
- The State 138
- Listing Menu 138
- State Listing 140
- • Trigger 141
- • Start (of a trace) 141
- Timing/State 144
- Mixed Mode 144
- State/State 145
- • addresses of machine 1 146
- • status of machine 2 146
- Time-Correlated 148
- Displays 148
- Using The Timing Analyzer 149
- Connecting the 152
- Configuring the 152
- Timing Analyzer 152
- Specifying a 155
- Condition 155
- Acquiring the 156
- The Timing 158
- Waveform Menu 158
- Making The 160
- Measurement 160
- Finding the 161
- Using The State Analyzer 163
- What Am I 164
- Going to 164
- Measure? 164
- How Do I 165
- Configure the 165
- Logic Analyzer? 165
- State Analyzer 168
- Specifying the 172
- 8 - 12 Front-Panel Reference 174
- State Compare Menu 185
- Accessing the 186
- Compare Menu 186
- The Compare 186
- Listing Displays 186
- Creating a 187
- Compare Image 187
- Bit Editing of 188
- Channels in the 189
- Compare Range 190
- Repetitive 191
- Comparisons 191
- State Waveform Menu 193
- Selecting a 194
- Waveform 194
- Replacing 197
- Deleting 197
- • Accumulate Mode 198
- Scaling the 200
- The Label Value 201
- States Chart 201
- Label Value 202
- X&OMarkers 203
- What Additional 211
- Measurements 211
- Must I Make? 211
- Setting the 214
- Time Correlating 215
- Overlapping 219
- Re-acquiring 221
- Using a Printer 223
- Printing On 224
- Screen Data 224
- Printing Entire 224
- Microprocessor 225
- Microprocessors 226
- Supported by 226
- Preprocessors 226
- Z80 CPU Package: 40-pin DIP 227
- 8085 CPU Package: 40-pin DIP 229
- 68008 CPU Package: 40-pin DIP 236
- 68000 and 68010 237
- (64-pin DIP) 237
- (68-pin PGA) 238
- Inspection 245
- Requirements 245
- Probe Cable 246
- Installation 246
- Operating 250
- Environment 250
- Tagging for 251
- Error Messages 252
- Specifications 255
- Characteristics 256
- Configurations 257
- State Analysis 257
- Timing Analysis 259
- Time Interval 260
- Accuracy 260
- Functions 261
- Run/Stop 262
- Environments 263
- Warranty 271
Related products and manuals for Unknown HP 16500A
Unknown HP Compaq WF1907 User Manual
(48 pages)
(48 pages)
Unknown HP C4342 Setup Guide
(8 pages)
(8 pages)
Unknown HP iPAQ Glisten-AT&T User's Guide
(28 pages)
(28 pages)
Unknown HP 3586C User Manual
(122 pages)
(122 pages)
Unknown HP 465A User Manual
(31 pages)
(31 pages)
Unknown HP 5150A User Manual
(98 pages)
(98 pages)
Unknown HP Elite 9096375NOV96528 User Manual
(18 pages)
(18 pages)
Unknown HP 10-Base-T User's Guide
(50 pages)
(50 pages)
Unknown HP MT40 User Manual
(10 pages)
(10 pages)
Unknown HP 8753C User Manual
(224 pages)
(224 pages)
Unknown HP Stroller 11690A User Manual
(9 pages)
(9 pages)
Unknown HP TS5220 User Manual
(2 pages)
(2 pages)
Unknown HP Switch 3 User Manual
(11 pages)
(11 pages)
Unknown HP Toaster 4815A User Manual
(7 pages)
(7 pages)
Unknown HP C5280 Setup Guide
(12 pages)
(12 pages)
© 2020, manymanuals.com. All rights reserved. | 0.828 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals