Hp Insight Management-Software User Manual download pdf (Page 89)

For more information about supported Virtual Connect firmware, go to http://www.hp.com/go/

vcem.

Creating a server profile fails

Attempting to create a profile can fail if any of the following situations occur:

• VCEM does not have enough free MAC or WWN addresses

• Some MAC or WWN addresses are already being used by another server profile.

• The MAC or WWN addresses in use by the VC Domain are not defined as custom ranges in

VCEM.

To resolve this:

1. Verify VCEM has enough free MAC and WWN addresses.

2. Verify that there are no MAC or WWN address conflicts for the VC Domain to be added to

the VC Domain Group.

3. Create MAC and WWN custom ranges, and then verify that the ranges contain the MAC

and WWN addresses from the server profiles defined in the VC Domain to be managed by

VCEM.

4. Perform the operation again.

Server profile edit operation fails when target server is powered on

The -set profile command can fail if the target server is powered on and the update attempts

to:

• Add, remove, or change an Ethernet network connection

• Add, remove, or change Fibre Channel SAN connections

An error message similar to the following is displayed in the job status:

Error during Edit server profile [Profile Name]. Details: This action

could not be performed because the server is powered on. Power down the server

associated with the Server Bay and retry the operation.

The -set profile command does not prevent profile edit operations if the target server is

powered off. However, the -set profile command can fail depending on what profile changes

each VC Domain firmware version allows when the target server is powered on.

Server profile job completed with success but changes have not occurred

If a VC Domain is managed by VCEM, and the Onboard Administrator is brought out of Virtual

Connect Mode, the following error message appears the next time you log on to Virtual Connect

Manager:

The HP virtual connect has lost its login credentials for the HP Onboard Administrator (OA).

OA may have been replaced or reset to factory defaults. To ensure proper operation, these credentials

must be reestablished

When the Onboard Administrator credentials are provided, an error message appears stating that

the credentials are not valid. This situation can occur when:

• Onboard Administrator has been replaced or reset to factory default settings.

• The clear vcmmode command was executed in the Onboard Administrator command line

interface

• The VC Ethernet modules were temporarily replaced by another BladeSystem c-Class

interconnect module.

Creating a server profile fails 89

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 95 96

Comments to this Manuals

No comments

Hp Insight Management-Software User Manual Page 89

Comments to this Manuals

Related products and manuals for Software Hp Insight Management-Software