HP DesignJet 500ps User Manual download pdf (Page 4)

Welcome

Welcome to the User Guide for the HP DesignJet 500PS RIP Software. We recommend

that you read and understand this document, and if necessary print it for future reference.

To print this document from Adobe Acrobat Reader, select File>Print from the menu bar.

This User Guide is copied to your computer as part of the installation. If you need to

locate it for future reference, it is stored in the HP DesignJet 500PS directory. This

document contains instructions for the Macintosh and Windows 95/98, Windows 2000

and Windows NT.

System Requirements Macintosh

The following table lists the minimum and recommended system setup to run the RIP

Software. System requirements vary according to the size of the files to be printed, the

output device used, and other variables. Your particular setup and intended use of the

software determine what hardware and software setup you need to get the most out of

the RIP Software. If you are working with relatively small files, the minimum setup may be

sufficient. Similarly, if you are working with large files, you should consider the

recommended setup. Consult your dealer for advice when choosing a system.

Minimum Recommended

PowerPC 166 G3 or G4 300 MHz or faster

Operating System Mac OS 8.5.1, 8.6 or 9.x Mac OS 9.x

RAM

*64 MB RAM *128 MB RAM or greater

Hard Drive space

available

500 MB Free Disk

Space

1 GB Free Disk Space or larger

Video 800 x 600 screen

resolution with 16 bit

color (thousands of

colors)

800 x 600 screen resolution with

16 bit color (thousands of colors)

Other CD-ROM Drive CD-ROM Drive

USB Port for security

device

USB Port for security device

Appearance Manager

and ColorSync installed

Appearance Manager and

ColorSync installed

Network 10 BASE-T 100 BASE-TX

* Requires virtual memory enabled. Set to 196-MB minimum.

1 2 3 4 5 6 7 8 9 ... 35 36

No comments

HP DesignJet 500ps User Manual Page 4