HP Visualize c3000 Instruction Manual download pdf (Page 44)

44 Chapter1

System Overview

Powering Up Your System

Turning on the Power

1. Turn on the monitor and any external peripherals (for example,

printers) connected to the workstation.

2. Turn on the workstation. The workstation will run a series of

self-tests.

3. After two or three minutes, a series of messages are displayed as

various hardware and software subsystems are activated. Unless

something is wrong with your system, you are not asked to respond to

these messages.

4. A series of windows appears requesting the information you gathered

in the previous section, such as your host name, IP address, and time

zone. Enter the information as it is requested.

NOTE You should enter the host name when requested; otherwise, you will get

an error message when you log in.

If you do not have other pieces of information, press Enter to use the

default value. You can provide missing information later by logging into

a terminal emulator window as superuser and executing this command:

/sbin/set_parms

5. You are now asked if you want to set a root password. Specify the

root password now. The root password is the password used for the

superuser account. The superuser is a special user who has

permission to perform all system administration tasks. The user

name for the superuser is root.

6. When you have ﬁnished answering all of the questions, the

workstation completes its start-up sequence and displays the CDE

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 245 246

No comments

HP Visualize c3000 Instruction Manual Page 44