HP Vectra XE310 Troubleshooting Guide download pdf (Page 14)

Upgrading and Replacing PC Hardware

Installing an Expansion Card

Note For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel (refer to “Removing and

Replacing the Side Panel & Air Flow Guide” on page 12).

2 Locate the slot you want to use.

• If fitting a card in an empty slot, undo the screw holding the slot cover in place and remove it.

• If replacing a card in an expansion slot, undo the screw holding the card in place and lift it out.

3 Aligning the new card carefully, press it firmly into the socket and tighten the retaining screw.

4 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel & Air Flow Guide” on

page 12).

5 Reconnect the power cord.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

HP Vectra XE310 Troubleshooting Guide Page 14