1 13 Alternative Rack Mounting (4-Post) Version 2, April 2001 Introduction This chapter provides the instructions for mounting the HP Netserver in a
Chapter 13 Alternative Rack Mounting (4–Post) 10 PinsSpringLatches (2) Figure 13-6. Attaching the Bezel to the Netserver Continuing with the Rack In
Chapter 13 Alternative Rack Mounting (4–Post) 2 Before mounting the Netserver, determine the Netserver's location in the rack relative to other
Chapter 13 Alternative Rack Mounting (4–Post) 3 in the high-density racks and additional information for rack systems not listed in this manual. You
Chapter 13 Alternative Rack Mounting (4–Post) 4 Preparing the Rack The outer-rail assemblies have spring assemblies that must be removed after shipm
Chapter 13 Alternative Rack Mounting (4–Post) 5 2. Remove the coiled wire spring at both ends (outer rail and sliding mechanism). See Figure 13-2.
Chapter 13 Alternative Rack Mounting (4–Post) 6 NOTE Use the HP Rack Configuration Tools to determine where in the rack to mount the HP Netserver.
Chapter 13 Alternative Rack Mounting (4–Post) 7 2. Lower the leveler screws on the rack's lower four corners to make firm contact with the fl
Chapter 13 Alternative Rack Mounting (4–Post) 8 Placing the HP Netserver in the Rack Use this topic to insert the HP Netserver into the outer-rail a
Chapter 13 Alternative Rack Mounting (4–Post) 9 Figure 13-5. Mounting the HP Netserver 5. Slowly move the Netserver chassis into the outer-rail a
Comments to this Manuals