Chapter 2 Installation
25
Step 12: Verify Installation
Verify the installation of the second hot-swap mass storage cage and the drives in
it. To do so, verify that all of the hot-swap drives are operational by using one of
the following:
Hard disk drive LEDs: See "Verifying Hard Disk Drive Operation"
below.
HP DiagTools: Run this diagnostic utility to verify the hard disk drive
modules. Refer to your HP NetServer’s installation guide, or download HP
DiagTools and its guide.
To download, go to
http://www.hp.com/go/netserver/, select
Technical Support, and then select Troubleshooting. Download the latest
version of HP DiagTools and the guide for it.
Verifying Hard Disk Drive Operation
Each Ultra2 hard disk drive module has two LED indicators on its front, one for
status and one for activity, as shown in Figure 2-14.
Indicator
Indicator
Figure 2-14. LED Apertures on Ultra 2 Hard Disk Drive Module
Comments to this Manuals