HP KAYAK XM600 User Manual download pdf (Page 7)

HP Kayak XM600 Series 2 Desktop PC Workstations

Medium-Profile

Desktop

PC Workstations

HP Kayak XM600 Series 2 Desktop PC

Workstations 1-7

Installing a Dual Processor / Replacing a Processor

HP Kayak XM600 Series 2 Desktop PC Workstations are supplied with a

Pentium III processor and an integrated VRM (Voltage Regulator Module) on

the system board. A separate VRM is not required.

Single processor models can be upgraded to dual processor systems by

installing a second processor accessory in the vacant processor socket.

The second processor must be a processor of the same type, speed and level-2

cache memory capacity as the first.

After installing a second processor in a Windows 2000 Workstation PC,

configure the system using the Windows Control Panel.

NOTE: The processor type and speed is automatically

recognized by the BIOS. This means that no particular

switch setting changes are required.

Main Memory

The HP Kayak XM600 Series 2 has two available RIMM sockets (RIMM0 and

RIMM1) on the system board. If RIMM1 socket is unused, it must contain a

“

RDRAM Continuity Module

”.

Memory upgrades are available in 64 MB, 128 MB or 256 MB ECC or non-ECC

RDRAM modules.

When upgrading memory, ensure that:

❒ Modules should be first installed in RIMM0 socket, then RIMM1.

❒ If RIMM1 socket is not used, install an “RDRAM Continuity Module”.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

HP KAYAK XM600 User Manual Page 7