HP Compaq dc7900 USDT Specifications Page 184

  • Download
  • Add to my manuals
  • Print
  • Page
    / 300
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 183
CAUTION: Before reinstalling the heatsink you must clean the top of the processor and the bottom of
the heatsink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply
thermal grease to the top of the processor from the syringe supplied in the spares kit.
CAUTION: When reconnecting the cables it is important that they be positioned so they do not interfere
with the rotation of the drive cage or power supply.
Backwall
1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock (Unlocking the
Smart Cover Lock on page 64)
2. Prepare the computer for disassembly (
Preparation for Disassembly on page 118).
3. Remove the access panel (
Computer Access Panel on page 125).
4. Rotate the drive cage to its upright position.
5. Remove the power supply (
Power Supply on page 169).
6. If necessary, remove the SmartCover lock from the backwall of the chassis using the special
security wrench and disconnect its cable from the system board (
Unlocking the Smart Cover
Lock on page 119).
7. Remove the system board (
System Board on page 171).
8. Remove the four screws that secure the backwall assembly to the chassis (1), slide the backwall
assembly toward the front of the chassis, and then lift it out of the chassis (2).
Figure 8-67 Removing the backwall
To replace the backwall, reverse the removal procedures.
172 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Page view 183
1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 299 300

Comments to this Manuals

No comments