HP Broadband Service Analyzer User Manual

HBroadband Service AnalyzerSetting Up the25.6 Mb/s Interface Pod

To Set Up the Interface Pod6To Set Up the Interface PodCaution Handle the interface pod with care to avoid electrostatic discharge (ESD)damage during

7To Set Up the Interface PodTo Insert the Interface PodYou can insert and remove interface pods at any time, even when theanalyzer is powered on. Init

To Set Up the Interface Pod8To Remove the Interface PodWhen you remove the interface pod, make sure you store it in a dust freelocation that meets the

9To Set Up the Interface PodSome common system and test connections are• an intrusive system connection—network element• remote loopback• in-line test

To Set Up the Interface Pod10Automatic Configuration ParametersAfter you insert the interface pod and connect it to the SUT, the analyzerautomatically

11To Set Up the Interface PodTo Manually Configure the Interface Pod• Note See the UNI Signaling Test Application’s Help for informationon configuring t

What to Do Next12X8 Timing Marker Source SettingWhen you change the X8 timing marker source setting, the trafficgenerator settings are cleared. The ana

13Standards and SpecificationsStandards and SpecificationsCommunications StandardsPhysical Specificationsaf-phy-004.400 ATM 25.6 Mb/s over Twisted Pair

Standards and Specifications14Environmental SpecificationsParameter Nominal Min. Max. NotesOperating Temperature5oC(41oF)45oC(113oF)with two interface

CertificationHewlett-Packard Australia Ltd (HP)certifies that this product met itspublished specifications at the time ofshipment from the factory. HP

The information contained in this document is subject to change without notice.TO THE EXTENT ALLOWED BY LOCAL LAW, HEWLETT-PACKARD MAKES NO WARRANTY O

WarningsThe following general safetyprecautions must be observed duringall phases of operation, service, andrepair of this product. Failure tocomply w

AvertissementCet appareil répond aux normes de la“Classe de sécurité 1” et est muni d’un filde mise à la terre pour votre protection.Pour prévenir les

page inner marginhanging column right marginbody text left marginbody text bottom marginfooter rulling linefooter text base lineouter margin for text

iiiContentsGuide to the Broadband Service Analyzer Documentation...ivAbout the 25.6 Mb/s Interface Pod ...

Guide to the HP E5200A Broadband Service Analyzer DocumentationivGuide to the HP E5200A Broadband ServiceAnalyzer DocumentationThe HP E5200A Broadband

1About the 25.6 Mb/s Interface PodAbout the 25.6 Mb/s Interface PodOverview The HP E5129A 25.6 Mb/s Interface Pod is a self-contained, plug-inmodule.

Online Help2Online HelpThe Online Help provides all the information you need to use the analyzer.Refer to the HP Broadband Service Analyzer User’s Gui

3Front Panel at a GlanceFront Panel at a GlanceAccess(green LED) Lights each time the interface pod is accessed by thenetwork.Signal(yellow LED) Light

Cable and Line Connector Details4Cable and Line Connector DetailsThe HP E5129A 25.6 Mb/s Interface Pod’s connector pin configurationadheres to the spec

5Cable and Line Connector DetailsConnector Cable ConfigurationsThe interface pod comes with three cables:• part number E1619-64300 connects a user devi