HP 5300 Specifications download pdf (Page 17)

1-9

Introducing the HP ProCurve Series 5300xl Switches

Back of the Switch

Introducing the HP ProCurve

Series 5300xl Switches

Back of the Switch

Power Connector

The Series 5300xl Switches do not have a power switch; they are powered on

when connected to an active AC power source. The switches automatically

adjust to any voltage between 100-127 and 200-240 volts and either 50 or 60

Hz. There are no voltage range settings required.

Slot for Redundant Power Supply

A second, load-sharing redundant power supply (HP ProCurve Switch gl/xl

RPS, J4839A) can be installed in the back of the Series 5300xl Switches. To

provide true redundancy, this second power supply should be connected to a

different AC power source from the other supply. Then, if one AC power

source fails, the switch will continue to run.

Caution The switch redundant power supply is hot swappable, but, as indicated by the

caution statement on the power supply, it must be disconnected from AC

power before being installed or removed.

Because the switch can run on a single supply, removing a redundant supply

will not interrupt switch operation.

AC power connector

slot for installing optional

redundant power supply

Caution:

Refer to the installation guide for proper power cord selection.

Disconnect AC power from this power supply BEFORE installing or removing

the supply. Otherwise, damage to the equipment may result.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 99 100

No comments

HP 5300 Specifications Page 17