86 Section 7: Program Editing
you can check the program by executing it stepwise. This is done by
pressing  in Run mode.
Move to first line of program
A.
Keycode for line 001 (label).
Result of executing line 001.
Result: the base area of the can.
Wrapping. Â will not move program p
Run mode, Â will perform any instructions at the end of program
memory, such as n, t or G.)
Line Position
Recall that the calculator's position in program memory does not change
when it is shut off or Program/Run modes are changed. Upon returning to
Program mode, the calculator line position will be where you left it. (If you
executed a program ending with n, the position will be at line 000.)
Therefore, if the calculator is left on and shuts itself off, you need only turn
it on and switch to Program mode (the calculator always "wakes up" in Run
mode) to be back where you were.
Comments to this Manuals