HP F100 User Manual download pdf (Page 26)

26 HP ProLiant Cluster F100 Installation Guide

CAUTION: Installation using SmartStart assumes that

SmartStart is being installed on new servers. Any existing data on the

boot drive of the server will be erased.

Cluster-Specific SmartStart Installation

The SmartStart Poster describes the typical procedure for configuring and

installing software on a single server. The difference between running SmartStart

on a stand-alone server and running SmartStart for a cluster are noted as follows:

•

For the RA4100 using the ACU, you can configure the shared drives on both

servers. For cluster configuration, configure the drives on the first server,

then accept the same settings for the shared drives when given the option on

the second server.

When configuring drives through the ACU, create a logical drive with 510

MB of space to be used as the quorum disk.

IMPORTANT: Microsoft® recommends at least 500 MB for the cluster

quorum drive. The extra space for the logical drive size specified in the

ACU is to account for external disk size calculations used by the ACU.

Specifying 510 MB will ensure that the size of the disk will be at least

500 MB of formatted drive space for use as the quorum drive. Refer to

Microsoft® KB Article EN-280345

(http://support.microsoft.com/default.aspx?scid=kb;EN-US;280345

) or

the help documentation on the cluster node for more information on

cluster disk sizes.

SmartStart Installation Steps

Use the following sections to install the operating system on nodes 1 and 2 using

SmartStart.

Installing the Node 1 Operating System

IMPORTANT: Power down node 2 when setting up node 1.

1. Power up the hardware in the following order:

a. Power on the switch or Fibre Channel storage interconnect.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 45 46

No comments

HP F100 User Manual Page 26