HP 3330 Microtower Specifications download pdf (Page 185)

Table A-12 Solving Memory Problems

System will not boot or does not function properly after installing additional memory modules.

Cause Solution

A memory module is not installed in the DIMM1 or XMM1

socket.

Ensure that a memory module is installed in the DIMM1 or

XMM1 socket on the system board. This socket must be

populated with a memory module.

Memory module is not the correct type or speed grade for

the system or the new memory module is not seated

properly.

Replace module with the correct industry-standard device for

the computer. On some models, ECC and non-ECC memory

modules cannot be mixed.

Out of memory error.

Cause Solution

You have run out of memory to run the application. Check the application documentation to determine the

memory requirements.

Memory count during POST is wrong.

Cause Solution

The memory modules may not be installed correctly. Check that the memory modules have been installed

correctly and that proper modules are used.

Integrated graphics may use system memory. No action required.

Insufficient memory error during operation.

Cause Solution

Too many Terminate and Stay Resident programs (TSRs)

are installed.

Delete any TSRs that you do not need.

You have run out of memory for the application. Check the memory requirements for the application or add

more memory to the computer.

Power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps

five times. (Beeps stop after fifth iteration but LEDs continue flashing.)

Cause Solution

Memory is installed incorrectly or is bad. 1. Reseat DIMMs. Power on the system.

2. Replace DIMMs one at a time to isolate the faulty

module.

3. Replace third-party memory with HP memory.

4. Replace the system board.

Solving Memory Problems 175

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 230 231

No comments

HP 3330 Microtower Specifications Page 185