HP L1940 User Manual download pdf (Page 20)

Setting Up the Monitor

Removing the Monitor Base

The monitor base can be removed to mount the monitor on a wall,

a swing arm or other mounting fixture. Read the caution and

warning statements below before beginning the procedure.

CAUTION: Before beginning to disassemble the monitor, be sure the

monitor is turned off and the power and signal cables are both

disconnected.

Lay the front bezel down on a soft area to prevent it from getting

scratched, defaced, or broken

WARNING: Do not remove the base from the monitor while the

monitor is in the upright position. Before removing the monitor from

the base, ensure that the monitor is lying flat, front bezel down, and

that the base is set to the maximum base extension. Attempting to

remove the monitor from the base while upright in the minimum base

extension may result in injury to the user.

1. Disconnect and remove the signal and power cables from the

back of the monitor.

CAUTION: Ensure that the bottom of the monitor base is positioned

over a table or desktop before removing the base from the monitor.

3–10 User Guide

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

No comments

HP L1940 User Manual Page 20