HP ZBook 17 Mobile Workstation User Manual download pdf (Page 62)

This provides the advantage of having a hard disk drive (or a RAID volume) for maximum storage

capacity while simultaneously delivering SSD enhanced system performance experience.

If you add or upgrade a hard drive and intend to set a RAID volume, you must temporarily disable

SRT, set the RAID volume, and then enable SRT. To temporarily disable SRT:

1. Select Start > All Programs > Intel > Intel Rapid Storage Technology.

2. Click the Acceleration link, and then click the Disable Acceleration link.

3. Wait for the Acceleration Mode to complete.

4. Click the Reset to Available link.

IMPORTANT: You must temporarily disable SRT when changing RAID modes. Make the change

and then re-enable SRT. Failure to temporarily disable this feature will prevent you from creating or

changing RAID volumes.

NOTE: HP does not support SRT with self-encrypting drives (SEDs).

Removing or replacing the service door

Removing the service door

Remove the service door to access the memory module slot, hard drive, and other components.

1. Remove the battery (see

Inserting or removing the battery on page 39).

2. With the battery bay toward you, slide the service door release latch to the left (1), and then

remove the optional screw (2).

3. Slide the service door release latch to the left again (3), slide the service door forward (4), and

then lift to remove the service door (5).

NOTE: If you do not want to use the optional screw, you can store it inside the service door.

52 Chapter 8 Drives

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 106 107

No comments

HP ZBook 17 Mobile Workstation User Manual Page 62