HP OMNIBOOK 4100 User Manual download pdf (Page 34)

HP OmniBook 4100/4150 Removal and Replacement 2-11

Removing the Display Assembly

(HP Authorized Service Providers Only)

Required Equipment

• Small Phillips screwdriver.

Removal Procedure

1. Unplug the ac adapter, if present, and remove the battery.

2. On the back of the unit, lift up on the VGA connector cover above the VGA port and unsnap it

from the case.

3. Remove the screw above the VGA port.

4. Remove the four “D” screws from the bottom case.

5. Open the display about 90 degrees, then lift off and lay back the combined top-case strip cover

and display assembly. Do not lose the two springs from the bottom case.

6. Remove the two screws from the LCD flex cable end and unplug the cable.

Figure 2-6. Removing the Display

LCD flex cable

Strip cover

Screw, M2×4mm

VGA connector

cover

Screw, M2.5×5mm

Caution:

Install new screws after

removing the two 16mm

screws at the corners.

Screw, M2.5×16mm (2)

Screw, M2.5×19mm

(2)

Screw, M2.5×5mm

(1)

Note:

Loose spring located

in each hole (2).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 110 111

No comments

HP OMNIBOOK 4100 User Manual Page 34