HP 3070 B611 User Manual download pdf (Page 35)

8 Connectivity

• WiFi Protected Setup (WPS – requires WPS router)

•

Traditional wireless connection (requires router)

•

USB Connection (non-network connection)

•

Change from a USB connection to a wireless network

•

Connect a new printer

•

Change network settings

•

Tips for setting up and using a networked printer

•

Advanced printer management tools (for networked printers)

WiFi Protected Setup (WPS – requires WPS router)

These instructions are for customers who have already setup and installed the printer software. For first time

installation refer to the setup instructions that came with the printer.

To connect the HP All-in-One to a wireless network using WiFi Protected Setup (WPS), you will need the following:

 A wireless 802.11b/g/n network that includes a WPS-enabled wireless router or access point.

NOTE: 802.11n will only support 2.4Ghz

 A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The

computer must be connected to the wireless network that you intend to install the HP All-in-One on.

NOTE: If you have a Wi-Fi Protected Setup (WPS) router with a WPS push button, follow the Push Button

method. If you are not certain your router has a push button, follow the Wireless Settings Menu method.

Push Button (PBC) method

1. Press the WiFi Protected Setup (WPS) button on your router.

2. Press and hold the Wireless button on the printer until the wireless light starts blinking. Press and hold for 3

seconds to start WPS push button mode .

NOTE: The product begins a timer for approximately two minutes in which the corresponding button on the

networking device needs to be pressed.

Wireless Settings Menu method

1. Press the Wireless button on the printer to display the Wireless menu. If the printer is printing, in an error state,

or performing a critical task, wait until the task has been completed or the error cleared before pressing the

Wireless button.

2. Select Wireless Settings from the printer display.

3. Select WiFi Protected Setup from the printer display.

4. If you have a Wi-Fi Protected Setup (WPS) router with a WPS push button, select Push Button, and then follow

the onscreen instructions. If your router does not have a push button or you are not certain if your router has a

push button, select PIN, and then follow the onscreen instructions.

NOTE: The product begins a timer for approximately two minutes during which the corresponding button on

the networking device needs to be pressed or the router PIN needs to be entered on the router’s configuration

page.

Traditional wireless connection (requires router)

To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will need the following:

Connectivity 33

Connectivity

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Comments to this Manuals

No comments

HP 3070 B611 User Manual Page 35

Comments to this Manuals

Related products and manuals for Inkjet printers HP 3070 B611