HP ESKO Workflow User Manual download pdf (Page 29)

Digital Proofing: Step by step

Recover a profile

If you have found mistakes in the measurement (see Verifying a profile (page 25)), you can correct the

mistakes by re-measuring the patches that were wrong. Please make sure the flaws are not in the

chart itself. When you have a fast spectrophotometer, sometimes remeasuring the complete charts(s)

is the easiest solution)

1. Open the printer/proofer process that you want to correct.

2. Go to the 'Overprints' tab.

3. Color Kit will now check which spectrophotometer is connected to your system. Only the layouts

available for this meter will be shown.

If the meter is not connected the following message will appear.

Please connect the meter and start again.

4. Select the type of chart you used to measure the profile.

5. Click the measurement button that corresponds with your meter.

6. Fill in the combination of C,M,Y and K where you want to start recovering.

Warning! If one of the numbers in the combination of CMYK

is 0, please fill in 0, do not leave the field blank!

7. Click 'Initialize'.

8. Click the measurement button.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 80 81

No comments

HP ESKO Workflow User Manual Page 29