Using the Exchange Deployment Tool (EDT)
Verify that you have the appropriate permissions, correct operating system version, and Active Directory
schema before proceeding to deploy Exchange 2010. The Prerequisite Checks screen runs a series
of tests to verify your configuration is set up correctly. If any test displays a Fail or Warning status,
you must fix the issue before you can continue.
AcknowledgmentResourceDescriptionStep
The wizard reminds you to obtain
your Exchange license if you have
not already done so.
Review and accept the end
user license agreement for
Exchange.
Accept the Microsoft Exchange
Jetstress 2010 end user license
agreement to proceed.
Review and accept the end
user license agreement for
Microsoft Jetstress.
For more information, see:
http://go.microsoft.com/?
linkid=9744747
Jetstress 2010 can verify the
stability and performance of the
disk subsystem prior to putting the
Optional but recommended:
Run Jetstress test.
Exchange server into production.
Select either the Normal or Quick
option.
Follow the screens of the EDT
to complete deployment.
Verifying the installation
Complete the following steps:
1. After exiting the EDT, you have the option to run the Exchange Best Practices Analyzer (ExBPA).
HP recommends running the analyzer after you have completed deployment on both servers.
2. Use the E5000 System Manager to monitor the messaging system. See the HP E5000 Messaging
System for Microsoft Exchange Administrator Guide for more information.
3. Launch the Exchange Management Console.
Migrating data and settings
If you are migrating from an existing Exchange 2003 or 2007 deployment, you may need a tool to
migrate your data and settings (mailboxes, settings, public folders) before deploying Exchange 2010.
Some available tools are:
• Quest Recovery Manager for Exchange (good for migrating public folders and permissions)
• Binary tools
• Exchange has built-in tools for migrating mailboxes.
Recording network details
Use the following table to record the various network details you will need for installation.
MAPI Network
Subnet mask:
Default gateway:
DNS:
DNS2:
Server 1 IP address:
Using the Exchange Deployment Tool (EDT) 9
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals