Hp Integrated Lights-Out 4 User Manual download pdf (Page 228)

Changing the server boot order

To change the boot order of floppy, CD/DVD-ROM, USB, hard disk, and network devices:

1. Navigate to the Virtual Media→Boot Order page, as shown in Figure 120 (page 228).

Figure 120 Boot Order page

When virtual media is connected, the iLO web interface displays the text Local Media next to

the Virtual Floppy/USB key and Virtual CD/DVD-ROM text at the top of the page.

2. Select a device in the Server Boot Order list, and click Up or Down to move it up or down in

the boot order.

You can select from the following devices:

• CD/DVD Drive

• Floppy Drive

• USB Storage Device

• Hard Disk Drive

• Network Device <number>, where the server Ethernet card is Network Device 1, and

additional NIC/ALOM cards are Network Device 2, Network Device 3, and so on.

NOTE: On servers that support the UEFI System Utilities, the Server Boot Order list shows a

device-specific name instead of the generic term that describes the device type. For example,

instead of Network Device, you might see Embedded FlexibleLOM 1 Port 1 : Broadcom

NetXtreme Gigabit Ethernet (BCM5719) (IPv4).

3. Click Apply.

Changing the one-time boot status

To set the type of media to boot on the next server reset, without changing the predefined boot

order:

1. Navigate to the Virtual Media→Boot Order page, as shown in Figure 120 (page 228).

228 Using iLO

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 355 356

No comments

Hp Integrated Lights-Out 4 User Manual Page 228