Hp 2/8q Fibre Channel User Manual download pdf (Page 132)

Command Line Interface

132 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide

Keywords

CONFIG [CONFIG_NAME]

Resets the configuration given by [config_name] to the factory default values for

switch, port, port threshold alarm, and zoning configuration. If [config_name] does

not exist on the switch, a configuration with that name is created. If you omit

[config_name], the active configuration is reset. You must activate the configuration

for the changes to take effect. See Table 45 through Table 47 for switch, port, and port

threshold alarm configuration default values.

FACTORY

Resets switch configuration, port configuration, port threshold alarm configuration,

zoning configuration, SNMP configuration, system configuration, and zoning to the

factory default values. The switch configuration is activated automatically. See

Table 45 through Table 50.

Note: Because this keyword changes network parameters, the workstation could lose

communication with the switch and release the Admin session.

PORT [PORT_NUMBER]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

SNMP

Resets the SNMP configuration settings to the factory default values. See Table 49 for

SNMP configuration default values.

SWITCH

Resets the switch without a power-on self test. This is the default. This reset disrupts

traffic and does the following:

— Activates the pending firmware.

— Closes all management sessions.

— Clears the alarm log. To save the alarm log before resetting, refer to the “Set Log

Command” on page 144.

To reset the switch with a power-on self test, refer to the “Hardreset command” on

page 124.

SYSTEM

Resets the system configuration settings to the factory default values. See Table 50 for

system configuration default values.

Note: Because this keyword changes network parameters, the workstation could lose

communication with the switch.

ZONING

Clears the zoning database and deactivates the active zone set. The zoning

configuration values (autosave, default visibility) remain unchanged.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 187 188

No comments

Hp 2/8q Fibre Channel User Manual Page 132