HP 7203dl User Manual download pdf

Quick Start Guide 5991-2113

ProCurve Secure Router 7203dl

J8753A

INSTALL THE INTERFACE MODULE

1. Verify the unit is not connected to a power source.

2. (Optional) To install the backup module, carefully align the P1 connector on the interface

module with the J1 connector on the backup module. Using only fingertip pressure to

ensure that neither circuit board bends or flexes, firmly seat the connectors. Secure the

backup module to the interface module using the supplied screws and standoff posts.

3. Slide the interface module into the option slot until the module is firmly positioned

against the chassis.

4. Secure the screws at both edges of the module.

5. To install the wide module, align the module with the wide slot and slide the module into

the chassis until it is firmly positioned against the backplane connectors. Secure by

tightening the screws.

GROUND THE ROUTER

1. Strip one end of the ground wire to the length required for the ring terminal. (Ground wire

and ring terminal are supplied by the user. For more detailed grounding specifications,

please refer to the ProCurve Secure Router Installation Guide.)

2. Crimp the ground wire to the ring terminal, using a crimp tool of the appropriate size.

3. Attach the ring terminal to the chassis as shown in the figure to the right.

4. Connect the other end of the ground wire to a suitable grounding point at your site.

5. Apply power to the unit.

Note

For information on installing the Encryption and Compact Flash modules

please refer to the ProCurve Secure Router Installation Guide included in

your router shipment.

CONNECT TO THE PROCURVE SECURE ROUTER 7203DL CONSOLE

Before connecting to the ProCurve Secure Router 7203dl Console interface you will need the

following items: VT100 terminal or PC (with VT100 terminal emulation software) and the serial

cable (5184-1894) supplied with your router. (This is the same console cable used in other

ProCurve switches such as the 5300xl series.)

1. Connect the DB-9 (female) connector of your cable to the DB-9 DTE (male) Console

interface on the front panel of the unit.

2. Connect the loose end of the cable to the VT100 terminal or PC (with terminal emulation

software).

3. Open a VT100 terminal session to the ProCurve Secure Router 7203dl using the

following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to

activate the HP Command Line Interface.

4. Enter enable at the > prompt.

5. Enter the password when prompted or press <Enter> if you have not yet set a

password.

Console

Power

Fault

Eth 0/1

Eth 0/2

Stat Stat

Slots

Bkp Bkp

Tx Tx

Rx Rx

Stat

Act

Test

dl dl

ProCurve 7203dl

Secure Router

J8753A

wide

1 2

ProCurve Secure Router 7203dl 1

Summary of Contents

Page 1 - ProCurve Secure Router 7203dl

Page 2

Comments to this Manuals

No comments

HP 7203dl User Manual

Browse online or download User Manual for Unknown HP 7203dl. HP 7203dl User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown HP 7203dl