HP 2209T User Manual

USER'S MANUAL L2105tm / 2209t LCD Touch Monitors Agency no.:

5 Connection instructions Installing the display Install: Remove: Place the display on the table (Figure 1) Packaging procedures If you need to pa

6 Connection instructions CAUTION: Before installation, please make sure to power off the display and the computer. (Figure 3) ○1 Power cord Con

7 Using the display Turning on the display Turn on the display before turning on the computer. When the power is on, the LED on the power button ligh

8 Operating the Touch Screen Touch Software Installation for Microsoft Windows 7 and Windows Vista (Plug and Play) Windows touch and multi-touch ges

9 Installing the Touch Driver from the CD (for Windows XP only) Insert the CD-ROM into the computer CD-ROM drive. The CD menu is displayed (or open W

10 3. Click “Finish” The driver setup installation is complete. 4. Click “Yes” After clicking Finish, the setup wizard will prompt

11 Control of the Touch Function NOTE: 1. Before using the touch function, make sure the USB cable is connected, the touch applications from the CD a

12 Using the Extended Display Setup Microsoft Windows 7 Operating Systems (Home Premium, Professional, Enterprise and Ultimate Editions) support exte

13 5. Click on the Calibrate… button. Perform a calibration on each monitor separately. NOTE: If you have two monitors that are

14 OSD selection Press the Menu button to activate the OSD function menu and continue pressing the Menu button to select an option from the 7 functio

Copyright © 2009-2011 Hewlett-Packard Development Company, L.P. All Rights Reserved. No part of this manual, including t

15 OSD CONTROL H.OSD POSITION: Controls the OSD menu’s horizontal position.V.OSD POSITION: Controls the OSD menu’s vertical position. OSD TIMEOUT:

16 Troubleshooting Problems Possible solutions Power LED doesn't light up.  Check if the power switch is in the ON position  Make sure the

17 Touch Screen Troubleshooting Tips Problems Possible Solutions Computer does not recover from sleep mode when the touch screen is touched Sleep m

18 Production Specifications LCD panel size 54.61 cm(21.5in) DCR 3000:1 (typical) Viewing angle Horizontal 170°, vertical 160° (typical) Response t

19 Preset Modes Preset Pixel Horz Freq (kHz) Horz Polarity Vert Freq (Hz) Vert Polarity Pixel Clk (MHz) Source 1 640 x 480 31.469 - 59.940 -

20 Appendix Connector pin assignment  15 pin color display signal cable: PIN No. Description PIN No. Description 1. Red 9. +5V 2. Green 10.

Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B d

Canadian Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing EquipmentRegulations. Avis Canadien Cet ap

Product Environmental Notices Materials Disposal This HP product contains mercury in the fluorescent lamp in the display LCD that might require spec

1 Table of Contents Safety Instructions ...

2 Safety Instructions  Please keep the display away from any heat sources such as electric radiators or direct sunlight. Place the display in a st

3 Recycling Information HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For mo

4 System components and accessories Use the provided stylus as a touch pointing device. However, the stylus is not required for optical touch