HP 3500ca Service Manual

HP Slate10 HD and HP Slate7 HDMaintenance and Service GuideIMPORTANT! This document is intended forHP authorized service providers only.

2 External component identificationHP Slate10 HDItem Component Item Component(1) Audio-out (headphone)/Audio-in(microphone) jack(6) Volume control but

HP Slate7 HDItem Component Item Component(1) Rear-facing webcamera (6) Speakers (2)(2) Microphone (7) Audio-out (headphone)/Audio-in(microphone) jack(

3 Illustrated parts catalogLocating the serial number, product number, andmodel numberThe serial number and product number of your tablet are located

HP Slate10 HD tablet major componentsItem Component Spare part number(1) Back cover (includes media card slot, power button actuator, SIM slot cover,

Item Component Spare part number(4) Microphone (includes cable and double-sided adhesive) 744533-001(5) Rear-facing webcamera (includes cable and doub

HP Slate7 HD tablet major componentsItem Component Spare part number(1) Back cover (includes card reader slot, SIM slot cover, grounding pads and tape

Item Component Spare part number(8) Battery, 3.7-V, 4000-mAh, 14.8-WHr, Li-ion battery (includes cable) 743895-001(9) Speakers (includes left and righ

Component Spare part numberFor use only on HP Slate7 HD tablet models 743047-001USB extension cable 751600-001Sequential part number listingSpare part

Spare part number Description744057-001 System board equipped with a Marvel PXA986 1.20-GHz dual core (SOC) processor, 1.0-GBsystem memory, a 16-GB eM

Spare part number Description744580-001 Power button/microphone module for use only on HP Slate7 HD tablet models (includes cable,double-sided adhesiv

© Copyright 2013 Hewlett-PackardDevelopment Company, L.P.Bluetooth is a trademark owned by itsproprietor and used by Hewlett-PackardCompany under lice

4 Removal and replacementpreliminary requirementsTools requiredYou will need the following tools to complete the removal and replacement procedures:●M

Grounding guidelinesElectrostatic discharge damageElectronic components are sensitive to electrostatic discharge (ESD). Circuitry design and structure

Packaging and transporting guidelinesFollow these grounding guidelines when packaging and transporting equipment:●To avoid hand contact, transport pro

Equipment guidelinesGrounding equipment must include either a wrist strap or a foot strap at a grounded workstation.●When seated, wear a wrist strap c

5 Removal and replacementproceduresTablet component replacement proceduresCAUTION: Tablet components described in this chapter should only be accessed

Remove the back cover:1. Place the tablet on a flat surface, display panel side up, with the speakers and the micro USB porttoward you.2.Insert a case

Remove the sensor module:1. Turn the back cover upside down with the bottom edge toward you.2.Detach the sensor module (1) from the back cover. (The s

CAUTION: Removing a battery that is the sole power source for the tablet can cause loss ofinformation. To prevent loss of information, save your work

7.Remove the six Phillips PM2.0×2.75 screws (1) that secure the battery to thedisplay panel assembly.8. Lift the top edge of the battery (2) and swing

Remove the power button board:1. Remove the rubber pad (1) that protects the power button board cable ZIF connector.2. Release the ZIF connector (2) t

Safety warning noticeWARNING! To reduce the possibility of heat-related injuries or of overheating the device, do notplace the device directly on your

4.Remove the back cover (see Back cover on page 18).5. Disconnect the battery cable from the system board (see Battery on page 20).Remove the volume b

3.Disconnect all external devices from the tablet.4. Remove the back cover (see Back cover on page 18).5.Disconnect the battery cable from the system

Rear-facing webcameraDescription Spare part numberRear-facing webcamera (includes cable) 744545-001Before removing the rear-facing webcamera, follow t

Audio boardDescription Spare part numberAudio board (includes audio jack and bracket) 744537-001Before removing the audio board, follow these steps:1.

Reverse this procedure to install the audio board.Card reader boardDescription Spare part numberCard reader board (includes cable, micro SIM slot, and

4.Remove the card reader board (4).Reverse this procedure to install the card reader board.SpeakersDescription Spare part numberSpeaker Kit (includes

3.Remove the four Phillips PM2.0×2.75 screws (3) that secure the speakers to thedisplay panel assembly.4. Remove the speakers (4).Reverse this procedu

Remove the USB board:1. Remove the rubber pad (1) that protects the USB board cable ZIF connector.2. Release the ZIF connector (2) to which the USB bo

System boardNOTE: The system board spare part kit is equipped with a Marvel PXA986 1.20-GHz dual core(SOC) processor, 1.0-GB system memory, and a 16-G

Remove the system board:1. Disconnect the following cables from the system board:(1) Left speaker cable(2) Power button board ZIF connector and cable(

iv Safety warning notice

2.Disconnect the following cables from the system board:(1) Microphone ZIF connector and cable(2) Rear-facing webcamera cable(3) Card reader board ZIF

4.Remove the system board (3).Reverse this procedure to install the system board.Front-facing webcameraDescription Spare part numberFront-facing webca

Remove the front-facing webcamera:1. Turn the system board upside down, with the bottom edge toward you.2.Release the ZIF connector (1) to which the f

HP Slate7 HDThere are as many as 16 screws that must be removed, replaced, and/or loosened when servicingthe HP Slate7 HD tablet. Make special note of

5.Remove the back cover (6).Reverse this procedure to install the back cover.BatteryDescription Spare part numberBattery, 3.7-V, 4000-mAh, 14.8-WHr, L

3.Release the tape (2) that secures the TouchScreen cable to the battery.4.Release the speaker cables from the retention clips (3) built into the batt

4.Remove the back cover (see Back cover on page 37).5. Disconnect the battery cable from the system board (see Battery on page 38).Remove the rear-fac

4.Remove the back cover (see Back cover on page 37).5. Disconnect the battery cable from the system board (see Battery on page 38).Remove the speakers

USB boardDescription Spare part numberUSB board (includes bracket, cable, double-sided adhesive, and micro USB port) 743044-001Before removing the USB

System boardDescription Spare part numberEquipped with a Marvel PXA986 1.20-GHz dual core (SOC) processor, 1.0-GB system memory, a16-GB eMMC solid-sta

Table of contents1 Product description ... 12

Remove the system board:1. Disconnect the following cables from the system board:(1) Rear-facing webcamera cable(2) Front-facing webcamera cable(3) Po

2.Disconnect the following cables from the system board:(1) USB board ZIF connector and cable(2) Speaker cable(3) TouchScreen module cable3. Remove th

4.Remove the system board (4).Reverse this procedure to install the system board.Antenna modulesDescription Spare part number3G antenna module 747947-

Remove the antenna modules:1. Remove the three Phillips PM2.0×2.75 screws (1) that secure the antenna modules to thedisplay panel assembly.2. Detach t

3.Disconnect all external devices from the tablet.4. Remove the back cover (see Back cover on page 37), and then remove the following components:a.Bat

4.Detach the power button/microphone module base plate from the 3G antenna module. (Thepower button/microphone module is attached to the 3G antenna mo

3.Disconnect all external devices from the tablet.4. Remove the back cover (see Back cover on page 37), and then remove the following components:a.Bat

6 SpecificationsHP Slate10 HD Metric U.S.DimensionsWidth 17.80 cm 7.01 inDepth 0.97 cm 0.38 inHeight 25.90 cm 10.19 inWeight (lowest weight configurat

HP Slate7 HD Metric U.S.DimensionsWidth 20.13 cm 7.93 inDepth 0.99 cm 0.39 inHeight 11.98 cm 4.72 inWeight 0.33 kg 0.72 lbInput powerThe tablet operat

7 Power cord set requirementsThe wide-range input feature of the tablet permits it to operate from any line voltage from 100 to 120volts AC, or from 2

Microphone ... 24Rear-facing webcamera ...

Country/region Accredited agency Applicable note numberGermany VDE 1Italy IMQ 1Japan METI 3The Netherlands KEMA 1Norway NEMKO 1The People's Repub

8 RecyclingWhen a non-rechargeable or rechargeable battery has reached the end of its useful life, do not disposeof the battery in general household w

IndexSymbols/Numerics3G antenna moduleremoval 46spare part number 9, 13, 46AAC adapter, spare part numbers10, 12antennaremoval 46spare part numbers 9,

product descriptionaudio 2display panel 1external expansion 3graphics 2mass storage 2memory module 2microphone 2operating system 3ports 3power require

1 Product descriptionCategory Description HP Slate10 HD HP Slate7 HDProduct Name HP Slate10 HD x HP Slate7 HD xProcessor Marvel® PXA986 1.20-GHz

Category Description HP Slate10 HD HP Slate7 HDGraphics 3D and 2d GPU2D hardware acceleration include DirectFB andalpha blendingSupports OpenGL ES 2.0

Category Description HP Slate10 HD HP Slate7 HDWireless networking Integrated WiFi option: WiFi 802.11abgn;Bluetooth and WiFi antenna support both 2.4