HP EliteDesk 800 G3 Tower PC User Manual download pdf (Page 16)

Replacing the front bezel

Insert the three hooks on the bottom of the bezel into the rectangular holes on the chassis (1), and then

rotate the top of the bezel onto the chassis (2) and snap it into place.

Removing and installing the optional front bezel dust lter

Some models are equipped with an optional front bezel dust lter. You must periodically clean the dust lter

so that the dust collected on the lter does not impede air ow through the computer.

NOTE: The optional front bezel dust lter is available from HP.

To remove, clean, and replace the dust lter:

1. Turn o the computer properly through the operating system, and turn o any external devices.

2. Disconnect the power cord from the AC outlet and disconnect any external devices.

NOTE: Regardless of the power-on state, voltage is always present on the system board as long as the

system is plugged into an active AC outlet. To prevent damage to internal components, you must

disconnect the power cord from the power source before opening the computer.

10 Chapter 2 Hardware upgrades

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 64 65

No comments

HP EliteDesk 800 G3 Tower PC User Manual Page 16