HP Elite Slice for Meeting Rooms G2 for Intel Unite User Manual download pdf (Page 18)

Removing modules

IMPORTANT: Before disconnecting modules, turn o the base module and disconnect it from any AC power

source.

Modules cannot be “hot-plugged” or “hot-swapped.”

Modules must be removed one at a time, starting at the bottom. Removing the bottom module exposes the

release latch of the module above it.

1. Remove/disengage the security cable, if one is attached.

2. Remove all removable media, such as USB ash drives.

3. Turn o the base module properly through the operating system, and then turn o any external devices.

4. Disconnect the AC power cord from the base module and disconnect any external devices.

5. If the VESA Plate is connected, slide the quick release latch on the back of the VESA Plate to the unlocked

position and lift the module stack o the VESA Plate.

6. Beginning at the bottom, remove additional modules by pressing the release latch (1) on the underside

of each module until it releases the module (2) above it.

10 Chapter 2 Setup

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

No comments

HP Elite Slice for Meeting Rooms G2 for Intel Unite User Manual Page 18