HP AD465A User Manual

AB465A PCI-X2-Port 2 Gigabit Fibre Channel and 2-PortGigabit Ethernet Combination Card InstallationGuideFor fcd Driver Versions B.11.11.04 and B11.23.

Hardware and Software Installation ProcedureCable Specifications10Note 3: The valid MTU size for normal frames using the igelan driver on HP-UX 11i v 1

Hardware and Software Installation Procedure11Figure 1 AB465A PCI-X 2-Port 2Gb FC/ 2-Port 1000B-T Combination Card(Duplex LC)Fibre Channel ConnectorsP

Hardware and Software Installation ProcedureFeatures12FeaturesThe AB465A PCI-X Combination cards have the following features:• PCI-X 133 MHz capable c

Hardware and Software Installation ProcedureInteroperability: Supported Systems13Interoperability: Supported SystemsSupported SystemsThe combination c

Card Physical and Environmental Specs and Regulatory InformationCard Physical and Environmental Specifications14Card Physical and EnvironmentalSpecs an

Card Physical and Environmental Specs and Regulatory InformationCard Physical and Environmental Specifications15Electromagnetic CompatibilityThis docum

Card Physical and Environmental Specs and Regulatory InformationFCC Statement (For U.S.A.)16FCC Statement (For U.S.A.)Federal Communications Commissio

Card Physical and Environmental Specs and Regulatory InformationLaser Safety Statements17Laser Safety StatementsLaser Safety Statements - U.S. FDA/CDR

Card Physical and Environmental Specs and Regulatory InformationLaser Safety Statements18

2Legal NoticesThe information in this document is subject to change without notice.Hewlett-Packard makes no warranty of any kind with regard to this m

Hardware and Software Installation ProcedureStep 1: Access the system card bay3Hardware and Software Installation ProcedureThese instructions apply to

Hardware and Software Installation ProcedureStep 4: Connect the fibre channel devices4• Attach the free end of the LAN cable to any unused port on the

Hardware and Software Installation ProcedureStep 6: Install the latest software.5• Check the Release Notes for GigEther-01 and FibrChanl-01 to see if

Hardware and Software Installation ProcedureStep 8: Verify the fibre channel installation6Step 8: Verify the fibre channel installation• To verify that

Hardware and Software Installation ProcedureOptional Step: Configure Jumbo Frames Size (Jumbo frames are supported only at 1000 Mbit/s)7• Installation

Hardware and Software Installation ProcedureFor Further Information8An alternative way to temporarily configure jumbo frame size is to enter:lanadmin -

Hardware and Software Installation ProcedureNetwork Configuration Worksheet9Network Configuration WorksheetFill out one worksheet for the networking dat